Rockwell Automation WebPak 3000 DC Drives Hardware Reference, Installation and Troubleshooting - Manual (Page 58)

4-16 WebPak 3000 DC Drive Hardware Reference
4.13 Checking the AC Line Period and Voltage
For a description of parameters AC LINE PERIOD (P.393), AC LINE VOLTAGE (P.392) and
PHASE LOSS DETECTION EN (P.609), refer to the WebPak 3000 Software Reference manual.
You can use these parameters to determine the AC line period, AC line voltage, and enable
phase loss detection.
4.14 Checking Drive Information
For a description of parameters J15 REGULATOR TYPE (P.799), POWER UNIT TYPE (P.795)
and REGULATOR SW VERSION (P.794), refer to the WebPak 3000 Software Reference manual.
You can use these parameters to determine the AC line period, AC line voltage, and enable
phase loss detection.
4.15 Power Supply Test Pin Identification
The following table lists the power supply PC board test pins and their respective voltage levels.
Since it is a switching power supply, all checks need to be made while load is connected to the
power supply card.
Test Pin Voltage Level
J4 to J5
J6 to J7
J8 to J7
J9 to J10
J11 to J12
J13 to J12
J14 to J16
J15 to J16
J3 to J16
+ 24 VDC
+ 12 VI
- 12 VI
+ 18 V
+ 15 VI
- 15 VI
+ 15 V
+ 5 V
- 15 V