Mount the 22b-v2p3n104 drive, Wire power, Mount the 22b-v2p3n104 drive wire power – Rockwell Automation Logix5000 Systems: Connecting PowerFlex 40 Drives over an EtherNet/IP Network Quick Start User Manual
Page 15: Mount the 22b, V2p3n104 drive
Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012
15
Prepare the PowerFlex 40 Drive Hardware Chapter 1
Mount the 22B-V2P3N104 Drive
You should mount the drive upright on a flat, vertical, and level surface with considerations for
minimum mounting clearance, ambient operating temperature, debris protection, and storage.
To complete the tasks described in this chapter, mount the 22B-V2P3N104 drive on a DIN rail.
For complete mounting instructions, see the PowerFlex 40 Drives User Manual, publication
.
Wire Power
1.
Loosen screws on bottom sides
of the cover.
2.
Pull the cover out and up
to release.
3.
Remove the cover.
WARNING: Verify that all incoming power is turned off before wiring power.
Do not turn incoming power on before connecting the EtherNet/IP adapter to the drive.