Rockwell Automation Logix5000 Systems: Connecting PowerFlex 40 Drives over an EtherNet/IP Network Quick Start - Manual (Page 20)

20 Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012
Chapter 1 Prepare the PowerFlex 40 Drive Hardware
7. Click Add to Relation List.
The New Entry dialog box
appears.
8. Type an IP Address,
Hostname, and Description for
the adapter.
9. Click OK.
10. To permanently assign this
configuration to the adapter, wait for the adapter to appear in the Relation List panel and
select it.
11. Click Disable BOOTP/DHCP.
When power is cycled, the adapter
uses the assigned configuration and
does not issue a BOOTP request.
Additional Resources
For a list of additional resources that might assist you when preparing the PowerFlex 40 drive
hardware, see
page 11 .
IMPORTANT If you do not click Disable BOOTP/DHCP, on a power cycle, the host controller clears the current IP configuration and begins
sending BOOTP requests again.