Rockwell Automation Logix5000 Systems: Connecting PowerFlex 40 Drives over an EtherNet/IP Network Quick Start - Manual (Page 17)

Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012 17
Prepare the PowerFlex 40 Drive Hardware Chapter 1
Connect the EtherNet/IP Adapter to the Drive
1. Before you connect the adapter
to the 22B-V2P3N104 drive,
record the Ethernet (MAC ID)
address.
You need this number to set an
IP address for the adapter, as
described in
Configure the EtherNet/IP Adapter on page 19 .
The MAC ID address uses format xx:xx:xx:xx:xx:xx where each x represents a letter
or numeral. The MAC ID is located on the adapter’s product ID label as shown in the
example graphic.
2. Mount the adapter on the drive cover.
3. Connect the Internal Interface
cable to the DSI port on the
drive.
4. Connect the mating DSI
connector on the adapter.
WARNING: Verify that all incoming power is turned off before connecting the adapter to the drive.
IMPORTANT You must use either a 22B-CCB Frame B drive cover or 22B-CCC Frame C drive cover with the PowerFlex 40
drive. These tasks use a Frame B drive cover.
22-COMM - E
00:00:BC:08:90:65
22-COMM-E
HW Address: 00:00:BC:08:90:65