Rockwell Automation Logix5000 Systems: Connecting PowerFlex 40 Drives over an EtherNet/IP Network Quick Start - Manual (Page 6)

6 Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012
Preface
Table 1 - Required Tasks to Complete Before Using this Quick Start
Task Description
Prepare the Logix5000
control system
hardware Assembling the control system and connecting to communication networks. Some components, for example,
the desired Logix5000 controller and system power supply, are required. Other components, for example, a
network communication module, are optional.
IMPORTANT: These graphics show the assembly of an example Logix5000 controller.
This task does not include installation of specific hardware components, for example, PowerFlex 40 drives, used
over the networks included in your application.
Prepare the computer Installing necessary software, such as RSLogix 5000 software, on your computer.
2 (Rear) 1 (Front)