Autocue WinCue Pro News Version 1.3 - Manual (Page 139)

WinCue Pro News User Guide IMT and SCSI cards • 139
13.1.3 Desktop systems (2940xx)
If the SCSI card is slow to initialise, for example, during boot up’s it waits at “Adaptec
aha-2940 scsi bios vX.XX.X”, or if you get the message “device connected but not
ready”, then you must down grade the SCSI card bios.
If the message “Fatal: WinCue Pro News could not find your hardware” appears,
then you have not installed the SCSI card or it’s drivers or you have not plugged in
your SCSI cable.
13.1.4 Desktop systems (2906)
If, when starting WinCue Pro News, the initialisation stops at 10% the problem is
caused by the version of the Windows driver for the Adaptec 'aic78xx.mpd'
This is located in: C:\WINDOWS\SYSTEM\IOSUBSYS\
The version needed to correct the problem is: AIC78xx.MPD = 31K, 24/08/1996, this
can be obtained from Autocue CD. DO NOT USE THE ADAPTEC DRIVERS
If the message “Fatal: WinCue Pro News could not find your hardware” appears,
then you have not installed the SCSI card or it’s drivers or you have not plugged in
your SCSI cable.
13.1.5 WinCue Pro News I/O Error
If you get the following error when you try to run the WinCue Pro News prompter,
then the Windows operating system thinks that the I.M.T card is a scanner device:
To fix this problem open the Devices Manager from the Windows Control Panel and
scroll down until you see the Scsiscan option.