Autocue WinCue Pro News Version 1.3 - Manual (Page 150)

WinCue Pro News User Guide IMT Card Information • 150
14.1.5 Video (PAL or NTSC) - J11
The I.M.T. card can produce either a PAL or NTSC composite video signal. The signal
available from the composite video port will have been set at the factory prior to
dispatch. The signal type can be changed by setting a jumper on J11 (Card Issue 1)
or with switch 3 (Card Issue 2).
Issue 1 Issue 2
14.1.5.1 SECAM
To configure the I.M.T. card for SECAM composite video output use the same jumper
setting as PAL on J11. In the WinCue Pro News software, from the Prompt menu
choose Configuration then Prompt Engine and ensure that Colour Burst is disabled.
These settings will generate a mono composite output.
14.1.6 Internal and External Power Supply - J12
If there is not an ISA slot available in your PC for the I.M.T card you will have to use the
J12 External Power Header (as shown in the diagram below) to connect the IMT card
to your PC's power supply. To do this firstly check to see if you have a free power
socket in your PC, then use the supplied power adapter cable to connect the J12
External Power Header to a free Power Header on your PCs power supply.