Autocue WinCue Pro News Version 1.3 - Manual (Page 14)

WinCue Pro News User Guide WinCue Pro News Installation • 14
1.5.2 Connecting a Scroll Control
Laptops normally use the I.M.T. scroll control. The I.M.T. scroll control port is the 9 pin
analogue port on top of the I.M.T. box. WinCue Pro News expects a scroll control to
be connected to this port.
The I.M.T. scroll control will not work if it is attached to any other port on your PC.
1.5.3 Connecting a Composite Video Feed
There are 2 versions of the I.M.T. box, one has four BNC composite outputs and the
other has one. These ports supply the composite video feed to the prompter
screen(s). You can connect your video cable to the BNC output.
See section 10.1 for further information about the IMT card layout.
1.5.4 Connecting a Genlock Feed
The genlock port is the BNC port next to the I.M.T. scroll control port on the I.M.T. box.
This port accepts a genlock feed.
1.5.5 Connecting a Power Supply
The I.M.T. box can be powered from one of three different sources; the mains power
supply, 12V DC and an optional PAG battery (UK version only).
A reset button is provided on the I.M.T. box to reset the I.M.T. scroll card.
1.6 Restarting Your PC
Once all the WinCue Pro News hardware has been installed restart your PC.