Autocue WinCue Pro News Version 1.3 - Manual (Page 148)

WinCue Pro News User Guide IMT Card Information • 148
14.1.1 Termination - J6
By Default the I.M.T. card is terminated and expects to be connected to the end of
the SCSI cable. Termination can be enabled/disabled by changing a jumper setting
on J6.
14.1.2 Power to Bus for SCSI Termination - J6
J6 is used to determine whether the I.M.T. card is terminated and to determine the
source of termination power.
If you have enabled termination on the SCSI card you will need to set the source of
termination power.
To enable external termination power for the SCSI bus
connect pins 5 and 7 of J6
To enable internal termination power to the SCSI bus
connect pins 7 and 8 of J6
14.1.3 SCSI ID - SW2
By default, SCSI ID is set to 3; it can be changed using dipswitches 1,2 and 3 on SW2.