Autocue WinCue Pro News Version 1.3 - Manual (Page 85)

WinCue Pro News User Guide Scroll Controls • 85
Select the type of control you wish to use and click OK.
8.3 Hybrid Serial/IMT Multibutton
This controller has two 9 way D connections, one is connected into the I.M.T port and
the other is connected to a free COM port. The 15 way D connector on the back of
the Multibutton controller is for a remote foot control unit.
If you need to change any settings for the selected hand control click on the setup
button
General tab Settings
Serial Port – This is the port that your Multibutton hand control is connected to.
Centre Stop Mode – This is set if you require your scroll control to change the
direction off the prompted text as well as controlling the speed of the text.
Stop Point – If you have centre stop mode enabled then this setting will increase the
dead zone.
Stop Zone – The Stop Zone is a range between 0 and 40 over which the prompted
text does not scroll. If the Stop Point is set to 60 and the Stop Zone is set to 5, scroll
rates between 55 and 65 will mean the prompted text is not scrolled.