Metrohm 794 Basic Titrino - Manual (Page 76)

2.16. Silo memory for sample data
794 Basic Titrino
72
>delete all silo lines
delete all: no
Delete all silo lines
Confirmation (yes, no)
When all silo lines are deleted, the silo is completely
empty: The line numbering starts again with 1.
cycle lines: OFF
save lines: OFF
With "ON", worked off silo lines will be copied to the
highest line of the silo memory (ON, OFF)
Data cycling "on" is useful if you constantly have to
process the same sample data. In such a case, the
processed silo line is not deleted, but copied to the
next free line, see below. If you work in this mode, you
should not enter any new silo lines during the
determinations.
Store results in the silo memory (ON, OFF)
Determination results will be stored as C24 or C25 in
the silo memory according to the allocations in the
methods, see page 73.
"save lines" can only be set to "OFF" if the silo is
completely empty.
Silo memory with data cycling "on"
Silo memory contains 35 lines.
Next free line is 36.
6 of 35 lines have been processed.
The processed lines have been
copied to the end of the silo
memory: your silo is filled up to line
41.
1 2 99
35
1 2 99
35
6
41