Metrohm viva 1.0 Manual - Manual (Page 442)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
430 ￭￭￭￭￭￭￭￭
viva 1.0
5.5.2.5.4 MEAS Opt
5.5.2.5.4.1 MEAS Opt - Overview
Dialog window: Method ▶ MEAS Opt ▶ Properties... ▶ MEAS Opt - 'Command
name'
Command for absorbance measurements.
Instruments
This command can be executed with the following instruments:
Spectrometer: Avantes
Photometer: 089
Appearance
The command has the following appearance:
Parameters
The parameters for the MEAS Opt command are set on the following
tabs:
￭ General/Hardware
Parameters for instrument.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Definition of evaluation results for absorbance measurements.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated by the MEAS Opt com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
BP{#}.[MEA] Measured value for the break point (1 - 9) in the unit
of the measured value
BP{#}.CNT Intensity for the break point x (1 - 9) in counts
BP{#}.TEM 1) Temperature for the break point # (1 - 9) in °C