Chapter 17. explanations of error message – IDX BMS User Manual
Page 73
User Guide for Battery Management System Ver4.2
Page 73/75
IDX Company, Ltd.
CHAPTER 17. Explanations of Error Message
1.
Data Communication Error (Read)
This error message is displayed when a communication error (read) has occurred while the BMS was
communicating with the hardware
2.
Data Communication Error (Write)
This error message is displayed when a communication error (write) has occurred while the BMS was
communicating with the hardware.
3.
Printer not installed
This error message is displayed when the printer driver has not been installed.
4.
Mode is not selected
This error message is displayed when the user has not yet selected a data acquisition mode.
5.
Cannot locate system Information
This error message is displayed when the computer cannot find software information.
6.
Error reading file
This error message is displayed when an error has occurred while reading saved data.
7.
Cannot find linked hardware
This error message is displayed when the hardware is not connected.
8.
System cannot be accessed. Device is not ready
This error message is displayed when the floppy disk drive, CD-ROM drive or other device is not ready.
9.
Error cannot find the file; IDXProf.dll (48)
This error message is displayed when there is no DLL file.
10. The selected file does not exist
This error message is displayed when the selected file cannot be found.
11. Battery User ID is not entered
This error message is displayed when a user battery ID has not been entered.
12. Communication error
This error message is displayed when the hardware is not or is incorrectly connected.