Cisco XR 12404 - Manual (Page 125)

5-1
Cisco XR 12404 Router Installation Guide
OL-13830-02
C H A P T E R
5
Maintaining the Router
This chapter contains safety at the field replaceable unit (FRU) level, removal and
replacement instructions for FRUs and procedures to troubleshoot the FRUs.
Your Cisco XR 12404 Router is equipped as ordered and is ready for installation
and startup when it leaves the factory. After you install and configure the router,
you may need to perform other procedures to ensure that the router continues to
operate properly. Also, as your networking requirements change, you may need to
upgrade your system by adding or changing components.
Before performing the procedures in this chapter, be sure to review the safety
information in the
“Laser Safety” section on page 2-6 , and the “Lifting
Guidelines” section on page 2-6 .
You should also be familiar with the Regulatory Compliance and Safety
Information for the Cisco 12000 Series Router document (78-4347-19) that came
with the router.
Caution All procedures in this chapter assume that you are wearing and ESD-preventative
wrist strap. Refer to
“Preventing Electrostatic Discharge Damage” section on
page 2-4 for additional information.
The following sections describe tools and procedures necessary to maintain the
Cisco XR 12404 Router.
• Tools and Equipment, page 5-2
• Powering Off the Router, page 5-3
• Removing and Installing the Front Cover, page 5-4
todd.book Page 1 Monday, March 16, 2009 2:47 PM