Cisco XR 12404 - Manual (Page 72)

Chapter 3 Installing the Router
Installing a Cisco XR 12404 Router
3-7
Cisco XR 12404 Router Installation Guide
OL-13830-02
Installing the Chassis in a Rack
Use the following procedure to install the Cisco XR 12404 Router in a rack.
Warning Two or more people should install the router to minimize the risk of personal
injury and damage to the equipment.
Step 1 Move the router as close to the installation location as possible without interfering
with the installation process.
Step 2 With one person lifting from the front and one from the rear of the chassis, lift the
chassis off the pallet and position the chassis in the rack.
Note A third person might be needed to assist in lifting and positioning the
chassis in the rack, or to install the screws once the chassis is in position.
Step 3 Install the screws to secure the chassis to the rack
a. Look at the bottom mounting holes on the chassis. Align one of the holes with
a mounting hole in the rack.
b. Install one of the mounting screws provided.
c. On the other side of the chassis adjust the position of the chassis so that the
same mounting hole in the bottom group of mounting holes is aligned with a
hole in the rack.
d. Install one of the mounting screws provided.
Step 4 Repeat Step 3 a through Step 3 d for additional mounting holes.
Step 5 Use a screwdriver to tighten all the screws.
todd.book Page 7 Monday, March 16, 2009 2:47 PM