Cisco XR 12404 - Manual (Page 86)

Chapter 3 Installing the Router
Connecting the PRP to an Ethernet Network
3-21
Cisco XR 12404 Router Installation Guide
OL-13830-02
Forwarding (CEF) functions are switched off by default for security reasons.
Cisco strongly cautions you to consider the security implications of switching on
CEF routing functions on these ports.
Figure 3-14 is an example of the functionality of an Ethernet port. In this example,
you cannot access Network 2.0.0.0 through the Ethernet port (ETH0) on the PRP
in router A; you can only access the hosts and router C, which are in Network
1.0.0.0 (see dotted arrows in
Figure 3-14 ).
To access Network 2.0.0.0 from router A, you must use an interface port on one
of your line cards (in this example, a Packet-over-SONET (POS) line card in
router A) to go through router B, through router C, and into Network 2.0.0.0 (see
solid arrows in
Figure 3-14 ).
Figure 3-14 Using the Ethernet Port on the PRP
PRP Ethernet Connections
Figure 3-15 shows a PRP RJ-45 receptacle and cable connectors. The RJ-45
connection does not require an external transceiver. The RJ-45 connection
requires Category 5 unshielded twisted-pair (UTP) cables, which are not available
from Cisco Systems, but are available from commercial cable vendors.
Table 3-3
lists the port pinouts for the RJ-45 receptacle.
Router A
(Cisco 12000 series)
Router B
(Cisco 7500 series)
Router C
(Cisco 7500 series)
POS
EO
Host A
Network 1.0.0.0
EO
Host B
S6755
Host A
Network 2.0.0.0
todd.book Page 21 Monday, March 16, 2009 2:47 PM