Tweco 51 with SL100SV CutMaster - Manual (Page 56)

OPERATION 4-14 Manual 0-4640
4
4.09 Cutting Speed Chart: Mild Steel, SL100 Torch with Exposed Tip
NOTES
* Gas pressure shown is for torches with leads up to 25' / 7.6 m long. For 50' / 15.2 m leads, increase pressure by 5 psi / 0.34 bar.
This information represents realistic expectations using recommended practices and well - maintained systems.
Actual speeds may vary up to 50% from those shown.
Electrode Start Cartridge Tip Shield Cup Body Shield Cap, Deflector
9-8215 9-8213 9-8237 9-8243
Art # A-04203
Torch: SL100 with Exposed Tip and Deflector
Power Supply: CutMaster 51 Automated
Tip Current
Plasma
Press.*
Pierce
Time
Arc
voltage
In GA mm Cat. # Amps PSI In mm SEC Volts in mm IPM mm/min
0.036 20 0.91 8-8208 40 65 0.188 4.8 0.00 96 0.19 4.80 341 8661.4
0.051 1.30 8-8208 40 65 0.188 4.8 0.00 97 0.19 4.80 300 7620
0.060 16 1.52 8-8208 40 65 0.188 4.8 0.10 98 0.19 4.80 265 6731
0.075 14 1.91 8-8208 40 65 0.188 4.8 0.30 100 0.19 4.80 190 4826
0.135 10 3.43 8-8208 40 65 0.188 4.8 0.40 101 0.19 4.80 120 3048
0.141 3.58 8-8208 40 65 0.188 4.8 0.50 102 0.19 4.80 112 2844.8
0.188 4.78 8-8208 40 65 0.188 4.8 0.60 107 0.19 4.80 60 1524
0.250 6.35 8-8208 40 65 0.188 4.8 1.00 111 0.19 4.80 40 1016
0.375 9.53 8-8208 40 65 NR NR NR 119 0.19 4.80 19.7 500.38
0.500 12.70 8-8208 40 65 NR NR NR 123 0.19 4.80 11.1 281.94
0.625 15.88 8-8208 40 65 NR NR NR 127 0.19 4.80 6 152.4
Material: Mild Steel
Table: Dry
Gas: Compressed Air
Recommended
Travel Speed
Stand-off
Height
Pierce Height Material thickness