04 removing skid, 05 input power connections – Tweco Merlin 6000GST Master PS User Manual
Page 22
INSTALLATION PROCEDURES
3-2
Manual 0-2652
D. Unpacking Procedure
1. Unpack each item and remove all packing material.
2. Locate the packing list(s) and use the list to identify
and account for each item.
3. Inspect each item for possible shipping damage. If
damage is evident, contact your distributor before pro-
ceeding with installation.
3.04 Removing Skid
The Power Supply is mounted on the skid with two brackets.
Remove the Power Supply from the skid as follows:
1. Remove the six bolts connecting the brackets to the base of
the Power Supply.
A-01760
Three Bolts
(Each Side)
Shipping Brackets
Shipping Pallet
Figure 3-1 Skid Removal From Power Supply
2. Roll the Power Supply off the skid backwards (rear wheels
first).
3.05 Input Power Connections
The Power Supply accepts input voltages from 200V to 575V, 50
or 60 Hz, three-phase power. Every Power Supply is factory
wired for 380-460V input. For any other input voltage, the Power
Supply must be reset.
NOTE
Refer to Section 3.07, Voltage Selection.
A. Electrical Connections
The power source must conform to local electric code and the
recommended circuit protection and wiring requirements shown
in Appendix 1.
B. Input Voltage Selection
Every Power Supply is factory-wired for 380-460V three-phase
input. For any other input voltage, the Power Supply must be
changed using the procedures in Section 3.07.