Tweco Merlin 6000GST Master PS - Manual (Page 41)

Manual 0-2652 4-3 OPERATION
7. Coolant Level Indicator
A slot provided in the rear panel allows the operator
a visual check of the coolant level. The coolant should
be above the indicator mark on the slot.
A-01755
1
4
2
3
6
7
8
9
18
5
12
14
16
17
13
15
11
10
Figure 4-5 Power Supply Rear Panel
8. Coolant Filter Assembly
The Coolant Filter Assembly on the rear panel is used
to filter the coolant as it returns to the reservoir. The
filter is a screen type which is easily cleaned or re-
placed.
9. Primary Input Power Cable Strain Relief
A strain relief supplied to secure the customer sup-
plied primary input power cable to the power sup-
ply. The input AC power cable is routed through the
strain relief and is connected to the power input ter-
minals inside the unit.
10. Remote Control and CNC Interface Connector
NOTE
For use with Remote Control RC6010 or Standoff
Control SC11. Refer to the Remote Control
(RC6010) Instruction Manual 0-2478 or the
Standoff Control (SC11) Instruction Manual 0-
2556 for more information.
REMOTE CONTROL connector (J15) used to inter-
face remote controls with mechanized systems. The
connector can be used to interface the Power Supply
with one of the following:
• Optional Remote Control (RC 6010) which al-
lows the operator to control all system func-
tions from a remote location.
• Optional SC-11 Standoff Control or other stan-
dard control (CNC) which allows the opera-
tor to control various functions of the mecha-
nized system from a remote location.
11. HFWS J48 (High Flow Water Shield) Connector
Output connector J48 is used to interface Optional
High Flow Water Shield to the Power Supply.
12. GAS CONTROL J55 Connector
Connector J55 is used to interface the Power Supply
to the Gas Control Module (GCM6000) Accessory.
13. PARALLEL CONNECTOR J54 Connector
Connector J54 is used to interface the Master Power
Supply to the Slave Power Supply with a Parallel
Cable.
14. SECONDARY H
2
0 (Water) Input Fitting
WARNING
The Optional Water Mist Secondary Flow Con-
trol Assembly must be installed when using water
as the secondary.
1/4 NPT female fitting used to supply the tap water
as a secondary gas to the Power Supply.
15. SECONDARY AIR Gas Input Fitting
1/4 NPT female gas fitting used to supply the air sec-
ondary gas to the Power Supply.