Tweco 300 Ultra-Cut(March 2013) - Manual (Page 3)

!
WARNINGS
Read and understand this entire Manual and your employer’s safety practices be-
fore installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best
judgement, the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply, Ultra-Cut ® 300
Operting Manual No. 0-5134
Published by:
Thermadyne Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
© Copyright 2009, 2010, 2011, 2012, 2013 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the
publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for
any loss or damage caused by any error or omission in this Manual, whether
such error results from negligence, accident, or any other cause.
Licensed under U. S. Patent No. 5,070,227
Original Publication Date: May 14, 2009
Revision Date: March 13, 2013
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
Torch Serial #:_______________________________________