Ultra-cut 300 – Tweco 300 Ultra-Cut(March 2013) User Manual
Page 49
Advertising
Manual No. 0-5134
3-25
INSTALLATION
ULTRA-CUT 300
3.15 Fiber Optic Cable Installation from CCM to DMC-3000.
1.
Remove outer thin nut from through hole protector at the end of Fiber Optic Cable (L) that is connectsed to
the CCM.
CAUTION
Avoid kinking, twisting, or bunching the fiber optic cable. The cable can be damaged by being forced
into tight-radius turns.
2. Ensure that the cable is exposed beyond the through hole protector approximately 1” (as shown below)
and secure by hand tightening the wide nut with the rounded end.
3. Feed the Fiber Optic Cable plug and wires through the hole where shown then slide the thin nut back over
the Fiber Optic Cable.
Art # A-09148
Advertising