Tweco 500SP PowerMaster Automation - Manual (Page 17)

POWERMASTER 400SP, 500SP AUTOMATION
March 16, 2007 2-1
SECTION 2:
INTRODUCTION
2.02 Equipment Identification
The unit’s identification number (specification or part
number), model, and serial number usually appear
on a nameplate attached to the control panel. In some
cases, the nameplate may be attached to the rear
panel. Equipment which does not have a control panel
such as gun and cable assemblies is identified only
by the specification or part number printed on the
shipping container. Record these numbers on the
bottom of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to shipping.
If there is any damage, notify the carrier immediately
to file a claim. Furnish complete information
concerning damage claims or shipping errors to the
location in your area listed in the inside back cover
of this manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-
crate the unit.
2.01 How To Use This Manual
This Owner’s Manual applies to just specification or
part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular
attention to the information provided under these
headings. These special annotations are easily
recognised as follows:
!
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment
damage.
NOTE
A NOTE offers helpful information
concerning certain operating procedures.
Additional copies of this manual may be purchased
by contacting Thermal Arc at the address and phone
number listed in the inside back cover of this manual.
Include the Owner’s Manual number and equipment
identification numbers.
Electronic copies of this manual can also be down-
loaded at no charge in Acrobat PDF format by going
to the Thermal Arc web site listed below and clicking
on the Literature Library link:
http://www.thermalarc.com