Tweco 500SP PowerMaster Automation - Manual (Page 59)

POWERMASTER 400SP, 500SP AUTOMATION
March 16, 2007 5-11
5.08 Robot Tool Software Installation
1. Insert the Installation floppy disk into your "A" disk
drive or the Robot Tool CD into your CD drive.
2. Click on "Start" and then click on "Run" and type in
the command printed on the disk label and click
on OK.
3. Follow the instructions given by the program
which installs the software. A new Robot Tool
icon will be created on the Windows desktop.
Program Description
The Robot Tool software is to control and monitor
the INT06 interface. The CAN-interface must first be
installed and functional. If not, please install the CAN-
interface first. For instructions refer to the Thermal
Arc Install section.
Start the software by double-clicking the icon on the
Windows desktop.
The actual states of the digital inputs are shown in
the upper part of the program window.
In the lower part of the program window, different
parameters/inputs can be enabled or disabled by click-
ing on the buttons 1-10. A clicked button means en-
abled a released button means disabled.
In the right part of the program window, all voltage
levels of the analog inputs are displayed as sliders
and their actual value.
The version of the operating system of the robot in-
terface is displayed in the status line below.
With the Drop-Down lists next to the buttons 1
through 8, any parameter can be assigned to the eight
analog inputs. Those assignments are also saved per-
manently into the machine. Assigning one parameter
to several inputs is not possible.
When assigning the parameters, notice that some
parameters are only usable in certain operating modes
(e.g.: "twinpulse frequency" on PowerMaster SP
Range is only available when the twinpulse mode is
active).
Art # A-07831