Tweco 500SP PowerMaster Automation - Manual (Page 23)

POWERMASTER 400SP, 500SP AUTOMATION
March 16, 2007 2-7
2.09 Features and Benefits Common to all PowerMaster SP Systems #
HARDWARE (Standard)
Inverter Design: Heavy duty, highly efficient,
environmentally toughened 80KHz design with
exceptional dynamic welding performance.
Flow Through Tunnel: Designed to circulate air around
components that require cooling and not over critical
circuitry. This reduces metallic dust ingression and
improves reliability.
Intelligent Heat Sensing Fan: Operates only as needed
to cool components and further reduce airborne
contaminants from being pulled through the power
source.
Simple, multi-voltage design from 200
to 500V for maximum flexibility in a single power
source.
Remote Control CAN-Bus Ports: Allow for easy data
transfer and provide full function remote control
capability.
4 Roll Drive Systems: All wire feeder drive systems
are high precision, 4 roll systems manufactured to
extremely tight tolerances for optimum feed-ability of
both hard and soft wires. Refer to page 3-8.
Heavy Duty Running Gear: All running gear has been
developed for manufacturing / production
environments, built heavy-duty and designed to last.
Tweco ® Guns and Accessories: Tweco ® has a full line
of PulseMaster standard and PulseMaster Smart Guns
with advanced digital controls optimized for the
PowerMaster SP range. Gun connections are Tweco
®
No. 4 and return leads are Tweco ® MPC. Refer to page
3-10.
SOFTWARE (Standard)
Links the wire feed speed, arc current
and voltage to deliver the perfect welding parameters
and eliminate the guesswork for achieving optimum
performance. Refer to page 4-2 item 52.
Effortless TIG-like weld appearance up
to seven times faster on aluminum and stainless steel
than traditional TIG (GTAW).
High Definition Pulse is expertly tailored,
optimized wave designs for perfect, digital
microprocessor controlled, pulse performance.
Built-in hardware and software
protection against accidental incorrect input voltage
selection.
JobTool™ is a library of 100 independent,
user-defined, job save programs. You can save and
recall welding procedures from a PulseMaster
SmartGun or from the front panel at any time. Refer
to page 4-3 item 62.
Fresh Tip Treatment sharpens the wire at the
end of the weld sequence ready for a perfect restart.
Recalls up to 100 personalized jobs with
perfect repeatability from the push of a button. Refer
to page 4-2 item 45 and 47 and to page 4-6 section
C 1-7.
Pre Programmed: Up to 100 optimized SmartMIG™,
PulseMIG and TwinPulse™ programs are standard,
delivering optimal performance and versatility.
Down Slope (Crater Fill Mode): The digitally
adjustable parameters reduce arc energy down
eliminating any craters that could cause defects.
#Subject to change without notification.