Tweco 500SP PowerMaster Automation - Manual (Page 44)

POWERMASTER 400SP, 500SP AUTOMATION
4-8 March 16, 2007
4.04 Special functions
A. Gas test
Pressing the pushbutton (51) and the “Gas type”
pushbutton (48) at the same time activates the gas
test function. The solenoid valve of the system is
activated and the gas flow rate can be checked /
adjusted. The function remains active for 30 seconds
and is then ended automatically. By pushing the “Gas
type” pushbutton (48) again, the gas test can be
terminated.
B. Pump test (where fitted)
Pressing the pushbutton (51) and the “Material”
pushbutton (44) at the same time activates the pump
test function. The coolant pump is switched on and
runs for approximately one minute. By pushing the
“Material” pushbutton (44), the pump test can be
terminated.
C. Resetting Adjustments
Pressing the pushbutton (51) and the “TT Enter”
pushbutton (47) at the same time resets all secondary
parameters to the Factory set values. When the
Tiptronic process is active, the settings of the current
job are reset. All adjustment in the Extras menu
(language, display contrast, etc.) remain unchanged.
D. Code lock function
The lock function in menu Extras is secured with a
code lock. A three-digit code must be entered before
the lock function can be changed. Only after the
correct code is entered, the lock function can be
altered. After leaving the menu, a new code number
can be set or the old code number is acknowledged.
Code “000” is the default (factory setting) number.
Procedure:
1. Switch to menu Extras, lock function
2. Press button (44) (-) or (48) (+) question
“change parameter ?” is displayed
3. Acknowledge with button (51)
4. Set three-digit code number with button (44)
(-),(48) (+) or encoder (53)
5. Acknowledge the code number with button (51)
6. Set desired lock function number with buttons
(44) (-) or (48) (+)
7. Leave menu with button (46) (END)
8. If requested, set a new code number with
buttons (44) (-) ,(48) (+) or encoder (53)
9. Acknowledge the code number with button
(51)