Unitec POS4000/V2 - Manual (Page 155)

POS4000
Document Number: POS4003 147
Document Title: POS4000/V2 Operations Manual
12 0 P1 Express Wash
This will allow 3 washes to be sold at the pumps ($6, $5, and $4).
To test this system:
• Get a code from each of the 3 possible wash types from the pumps then
do a code check on each verifying the wash names match.
• Get a code for each of the 3 possible wash types at each possible
discount from the Register then do a code check on each verifying the
wash names match. This verifies the EXTPOS connection is configure
properly
• Print a code at the regular price for each of the 3 wash types from the
POS4000 then use the washes at the coin box. This verifies the wash
wiring to the Mark VII was done properly.
• Pay for each of the 3 washes at the coin box using cash and verify the
proper wash type wash given. This verifies that the Buttons on the
Autotec are configured properly.
Appendix P. APPENDIX XV - Wash Select II POS system
The Wash Select II may be configured to interface to a POS4000 in order to be
activated by Codes sold at one or multiple POS4000 units. This is how a Wash
Select II/POS is configured to operate. Any Wash Select II may also be
upgraded in the field to interface to a POS4000 either by direct wires or via RF
(Radio Frequency) interface.
Upgrading a Wash Select II to interface to a POS4000 requires the following:
•
Version 1.20 or greater software installed into the Wash Select II
•
POS4000 with Version 7.20 or greater installed.
•
Wash Select II 485 communications module. This plugs into the
top left corner of the Wash Select II CPU board.
•
Cable to connect POS4000 to the Wash Select II 485
communications module
•
2 RF transceivers (Optional if your cable connection between the
POS4000 and Wash Select II is not feasible)
The Wash Select II may be configured to convey accounting information to the
POS4000 or to withhold that financial information. If you are in a revenue share
agreement, you may want to withhold the information. If not, you should convey
the accounting information to allow the POS4000 to see the money that is being
entered into the Wash Select II coin box.
The Wash Select II is mostly configured at the Wash Select II coin box. Most of
the coin box settings in the POS4000 are not used by the Wash Select II. You
may however configure the Wash Select II to accept the Wash names and Prices