SARGENT Keypad Exit Devices - Manual (Page 7)

Copyright © 2006, 2008, Sargent Manufacturing Company
, an A
SSA ABL
O
Y Group company
. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
800-810-WIRE (9473) • www.sargentlock.com • A7137B
Rim Installation Instructions for KP8800 Series (Continued)
Step #2 Install Outside & Inside Trim
2. Inside Trim
• Route “ET” harness along track cutout for wood doors and
access hole for metal doors
• Mount exit chassis carefully. DO NOT PINCH HARNESS WIRES
• “ET” spindle will engage into the hub of exit device chassis
• Secure chassis with (2) 1/4-20 x 2-3/8" flat head
machine screws
1. Outside Trim
• Route harness through under cut of cylinder
hole and out to other side of door
• Mount “ET” control onto door
4. Securing Cylinder
• Secure cylinder to exit chassis using
(2) #12-24 x 1-7/8" connecting screws
• Fasten exit chassis to door using (4) #10 wood
screws or #10-24 machine screws
3. Cylinder Installation (KP8877 & 12-KP8877)
• Insert cylinder into “ET” control
• Mate cylinder tailpiece into hub of exit device
chassis
• Make sure “ET” harness is clear of cylinder and
cylinder tailpiece
(#34)
Cylinder
C For (2) #12-24 x 1-7/8"
connecting screws L
ET control
Wire
harness
Center line for
(2) 1/4 - 20 x 2-3/8''
flat head
machine screws
Wire harness
(2) 1/4 - 20 x 2 3/8''
Flat head
machine screws
Exit chassis
Wire harness
(4) #10 Wood screws
or #10-24 machine screws
Exit chassis
Inside
of door
(2) #12-24 x 1- 7 ⁄ 8 ''
connecting screws
Outside
of door
Inside of
door
Outside
of door
Inside
of door
5
2