SARGENT Passport 1000 PG Mortise Locks - Manual (Page 11)

Inside of door
Fig. 5B1
Mounting
plate
(4) #8 - 32 x 1 - 7/8” flat
head machine screws
Attach ground
lug to bottom
right screw
Fig. 5C
(2) #8 - 3/8”
flat head
wood
screws or
(2) #8 - 3/8” flat
head machine
screws
Inside of door
Outside
Passport
Trim
Peel off adhesive
backing and attach to
(outside) escutcheon
Fig. 7A
Mounting Plate
Cables
Position lug upright, then
tighten screw
7B – Installation of Outside Escutcheon and
Mounting Plate Assembly
7A – Gasket Installation
1. Insert the mounting posts through holes as shown.
2. On the inside of the door, position the mounting plate
over the indicated holes.
Note: Feed controller and keypad cables through side
opening (Fig. 7B1).
Cable from lock body feeds thru bottom
(Fig. 7B2 & 7B3).
3. Attach grounding lug to bottom right screw and note
upright positioning of lug as shown (Fig. 7B1).
4. Insert other three corner screws and tighten, fastening
the outside escutcheon to the door (Fig. 7B2).
5. IMPORTANT: If the following step is skipped, the
product will not be UL-compliant:
Attach two (2) #8 x 3/8” flat head wood screws for wood
doors, or (2) #8-32 x 3/8” flat head machine screws for
metal doors (Fig. 7C).
Fig. 7B1
For non-fire rated door applications, an optional gasket
(Fig. 7A) may be used as a weather seal between the
escutcheon and the outside door surface.
Note: Optional, for non-fire rated doors only.
11 A7807C
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/12
Passport 1000 PG Mortise Lock