SARGENT Passport 1000 PG Mortise Locks - Manual (Page 7)

2 – To Change Hand of Lock Body
A. Retaining Ring
1. Peel back the sticker that covers the retaining ring and remove the retaining ring.
2. Orient the plastic retaining ring so that the word
BOTTOM is located at the bottom of the cylinder hole (Fig. 2A).
3. Route the wires from the top of the cylinder hole into the slot on the top of the plastic retaining ring, NOT th-
rough the retaining ring (Fig. 2A) and insert the retaining ring into the non-cylinder side of the cylinder hole.
4. The cable and connector must be coiled inside retaining ring before inserting mortise into door prep pocket
(Fig. 2B). Make sure the plastic retaining ring is seated correctly.
Fig. 2A
Slot
Plastic
Retaining Ring
Inside of Door
(non-cylinder side)
Fig. 2B
Harness must be coiled
inside Plastic Retaining Ring
NOTE: Lock body is shipped with a removable perforated
sticker covering the retaining ring on the non-cylinder
side (inside of door) of the lock body.
Cables and connectors are coiled inside the retaining ring.
1.
If the handing of the lock body does not need to be
changed, skip 2 and proceed to 3.
Perforated
Sticker
C. Prepare Lock Body
The lock body sticker states the following:
1. Ensure the handing is correct.
(To change handing, see Installation Instructions)
2. Insert lock body in door.
3. Press wire harness through sticker.
C. Reverse Latch Hand
Beveled surface of latchbolt must face strike (Fig. 2D).
The deadlatch is self adjusting.
To change the hand of the latchbolt:
1. Insert the blade of a slotted screwdriver (>1/4”)
into the spade shape slot behind latch.
2. Rotate the screwdriver 90° to push latchbolt out
until back of bolt clears lock case front.
3. Rotate latchbolt 180° until the latchbolt
drops back into the lock body.
Note: Latch cannot be unscrewed.
B. Reverse Lock Hand
Red surface of locking piece must face the outside/locked side of door. To rotate locking piece (Fig. 2C):
1. Position lock body with red surface of locking piece visible.
2. Insert blade type screwdriver into locking piece slot to rotate locking piece toward back of lock body.
3. Rotate the locking piece 180° until RED surface is on opposite side.
Note: Red indicates locked side (outside). Wire harness MUST exit through the non-cylinder side
(inside) of the lock body (Fig. 2D).
7 A7807C
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/12
Passport 1000 PG Mortise Lock