SARGENT HC8700 Hurricane Code Surface Vertical Rod Exit Device - Manual (Page 3)

3
APPLY CENTER CHASSIS AND TRIM
THIRD
Chassis
Bell housing
8706 OR 8713 BY
ETJ CONTROL SHOWN
Copyright © 2009-2011, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission
of Sargent Manufacturing Company is prohibited.
A6701L
11-30-11
700 SERIES ET TRIM:
1. Secure chassis to door with (4)
#10 flat head screws using corner
mounting holes.
NOTE: Electrical functions –
see instruction sheet A6374 for
wire connections.
2. Position ET trim on door, align
spindle with bell housing.
3. Through-bolt chassis to ET trim
with (2) 1/4-20 flat head screws.
NOTE: Thumb Trim is not available for HC8700
Series Exit Devices
800 SERIES THUMB PIECE TRIM:
Determining rim cylinder tail length
FOR FLL, FLW, MAL, STS OR PTB TRIM:
1. Position trim on door (except STS).
2. Insert rim cylinder through trim plate (or cylinder
collar for STS trim).
3. Mark cylinder tail at 5/16” beyond inside door
surface.
4. Remove cylinder and trim from door and cut tail
piece as marked.
APPLY CHASSIS AND TRIM:
1. Hold trim plate to door.
2. Insert cylinder and secure using supplied back plate.
3. Position cylinder hub with in the chassis to correct
position for desired function (see drawings).
4. Position chassis on door, align cylinder tail with hub
and secure chassis to door with (4) #10 flat head
screws using the corner mounting holes.
5. Through-bolt chassis to trim with 1/4-20 flat head
screws and to door with cup washer and 1/4-20
flat head screw.
NOTE:
STS, FLL, FLW and MAL thru-bolt to chassis
with (1) 1/4-20 flat head screw.
PTB trim through-bolts to chassis with (2) 1/4-20
flat head screws.
5/16"
STS TRIM
SHOWN
FLL TRIM
SHOWN
8762 OR 8763
BY FLW SHOWN
For 8763 long end of pin
faces up. Cylinder turns
360° to the left or right.
For 8762 long end of pin
faces down. Cylinder turns
180° in both directions.
Cylinder
hub
Hub pin
down for
62 function
Chassis