Marker maintenance (option), Marker shear bolt replacement, Marker chain length adjustment – Great Plains 3PYPA Operator Manual User Manual

Page 121: Led. see “ marker

Advertising
background image

Great Plains Manufacturing, Inc.

Table of Contents

Index

Maintenance and Lubrication

117

03/20/2012

Table of Contents

Index

401-647M

Marker Maintenance (Option)

See also:
Initial Marker Setup (Option)” on page 163,
Marker Operation (Option)” on page 49, and
Marker Disk Adjustment” on page 61

Marker Shear Bolt Replacement

Refer to Figure 141
If a marker gets caught or hits an obstruction, it is
designed to fail a shear bolt

at the fold, pivot on a sec-

ond bolt

, and swing back.

The shear bolt is a hex head cap screw,

7

16

-14 x 2in

Grade 5, Great Plains part number 802-589C, plus a

7

16

-14 lock nut, Great Plains part number 803-200C.

Install a replacement shear bolt on the vertical faces on
the side opposite from the pivot bolt

. Do not use a

higher grade bolt, or marker hang-ups may result in
machine damage. Do not use a lower grade bolt, or you
may experience nuisance shears.

Refer to Figure 142
If your planting frequently encounters shear hazards, you
can store 6 spare shear bolts/nuts per marker side, in
storage holes

at the fold point.

Marker Chain Length Adjustment

Great Plains suggests checking marker chain slack
every few years. If any maintenance or repairs cause the
chain to be disconnected, correct slack needs to be set
on reinstallation.

Perform any checks and adjustments with the marker
folded and tilted down into its cradle.

Refer to Figure 143
At the mid-point in the exposed chain, pull it toward the
front of the planter.

Measure the distance between that mid-point and the
nearest point on either of the two parallel tubes of the
marker intermediate arm. The target value is:

18 inches (46cm).

If the slack is more than one inch different, remove the
bolt and nut at the lower end of the chain and adjust the
length.

Equipment Damage Risk:
Keep chain slack within range. A chain length too short or too
long can result in marker damage.

Null4:

Figure 141

Marker Shear Bolt

25263

1

2

1

2

2

Null4:

Figure 142

Marker Shear Bolt Storage

25264

1

3

3

3

Null4:

Figure 143

Marker Chain Slack

25266

Advertising