Great Plains 1625AHL Operator Manual - Manual (Page 159)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix B - Pre-Delivery 155
2014-04-21 Table of Contents Index 411-020M
Note: Do not disturb, loosen or remove the forward two
bolts.
25. Align the
1 ⁄
2
inch holes in the press wheel assembly
with the
1 ⁄
2
-13 tapped holes in the row unit.
Add a lock washer to the
1 ⁄
2
-13
×1 inch hex head
bolt . Loosely screw into the rear
1 ⁄
2
inch hole.
26. Add a lock washer and the eccentric adjuster
to the
1 ⁄
2
-13
×1 1 ⁄
2
inch hex head bolt . Loosely
screw into the forward
1 ⁄
2
inch hole
27. Rotate the adjuster to visually align the press
wheel assembly with the row unit, and tighten
the8adjuster and bolts. See “Press Wheel
Centering” on page 86.
Figure 131
Long Press Wheel Mount
32191
18
18
7
40
29
40 21
26
21