Great Plains 3S-3000F Predelivery Manual - Manual (Page 15)

13
Section 2 Setup
8/9/06 3S-3000 Three-Section Folding Drill 195-144M
Great Plains Mfg., Inc.
1. Adjust The Wing Box Alignment
Refer to Figure 2-5, place a 4x4 or similar sized block
ahead of the wing gauge wheels. Pull forward or rock the
wing frames back until the toolbar stop bolt is firmly
against the stop plate on the center box frame. The toolbar
stop bolt runs through a formed channel on the bottom
side of the toolbar. Run a string line across the back of the
center box and out toward the outer ends of the wings. The
outboard ends of the wing boxes should be toed forward
about 1" ahead of the inboard ends. Adjust the wing box
alignment by controlling when the 1 1/4" toolbar stop bolt contacts the stop plate on the center box frame. Adjust
the 1 1/4" toolbar stop bolts in or out until the outer end of
the wing boxes are toed forward about 1".
Wing Box Alignment Measurement
Figure 2-5
15654
15655
Stop Bolt
String Line String Line
Support String Line
Support
A A B
C C
B
C-B=1" C-B=1"