ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 116)

Communication 4-35
 Conduit Mount the stub antenna to the end of a section of
conduit as follows:
 Obtain a section of conduit with a 5/8-inch (or slightly
greater) internal diameter.
 Determine the appropriate length of conduit required.
 Route the antenna cable through the conduit, and attach the
large male N-type connector from the antenna cable to the
threaded stud on the antenna.
 Use rubber stretch tape and sealer to attach and secure the
antenna to the conduit.
 Raise the conduit to the required height, and secure it to
the side of the manhole or wall using off-the-shelf clamps
or fittings.
 Run the other end of the cable to the monitor, and attach
the connector to the RADIO port on top of the monitor.
Note: If the antenna cable has the SMA connector, first
attach the SMA-to-TNC adaptor (ADS p/n 507173) to the
RADIO connector port on the monitor and then attach the
cable connector to the adaptor.
 Wrap rubber stretch tape around the entire cable
connection, extending onto the cable approximately 2
inches beyond the connection.
 Antenna Mast Mount the stub antenna to an antenna mast as
follows:
 Attach the large male N-type connector from the antenna
cable to the threaded stud on the stub antenna.
 Use rubber stretch tape and sealer to secure the
connection.
 Secure the antenna to the mast using clamps or other
applicable hardware.
 Run the other end of the cable to the monitor, and attach
the connector to the RADIO port on top of the monitor.