ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 149)

Configuration and Activation 6-23
3. Select or enter the communication parameters as necessary:
 Modem Name Select the modem you want to use during
modem communication from the drop-down list. This list
should include all available modems on your computer.
 Modem Port Select the proper port for modem
communication from this drop-down list. This list should
include all available ports on your computer.
 Serial Port Select the proper port for serial
communication from this drop-down list. This list should
include all available ports on your computer.
 DMI Port Select the proper port for communication using
the DMI from this drop-down list. This list should include
all available ports on your computer.
 Timeout Enter the number of seconds you want your
local computer to wait for a response from the monitor
once communication has been initiated.
 Attempts Enter the number of times you want your local
PC to request data from the monitor following failed
attempts while the monitor is still on line.
 Low Temperature Enter the temperature reading from
the monitor, ultrasonic depth sensor, and pressure depth
sensor below which you want Profile to provide
notification.
 High Temperature Enter the temperature reading from
the monitor, ultrasonic depth sensor, and pressure depth
sensor above which you want Profile to provide
notification.
 Log Communications Select this checkbox to record
all communication activities with the monitor.
 Status On Connect Select this checkbox to view
details concerning the current state of the monitor once
communication with the monitor has been established.
 Low Battery 1502, 1506, 3500, 4000 (These
parameters do not apply to the FlowShark monitor)