ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 139)

Configuration and Activation 6-13
5. Select the checkboxes corresponding to the devices you want to
assign to the designated monitoring point from the Available
Devices selection box. A checkmark must display beside a
device in the Monitoring Point Devices section to ensure
Profile includes the device in the LIF. Deselect the checkboxes
corresponding to the devices you want to remove from
association with the selected monitoring point from the
Available Devices section.
Note: Profile selects the Ultrasonic 1, Velocity 1,
Pressure 1, and MLI 1 devices for the FlowShark monitor
by default. The MLI device is not associated specifically
with a sensor. It represents special software included in the
monitor firmware that supports activities such as water
quality sampling and event notification.
The selected devices display in the Monitoring Point Devices
section.
6. Repeat steps 4 through 5 to assign devices to Monitoring Point
2, when applicable.
7. As necessary, edit the parameters specific to each device as
follows:
 Access the device parameters by selecting (highlighting)
the device you want to edit in the Monitoring Point
Devices section and then selecting the Edit button.
 Refer to the following sections for details concerning the
specific device parameters.
8. Once you have edited the devices as necessary, select the OK
button to save the devices to the LIF.