Canon mx860 - Manual (Page 309)

Staple Side. If you want to change the setting, select another value from the list.
5. Set the margin width
If necessary, click Specify Margin... and set the width of the stapling margin, and then click OK.
6. Complete the setup
Click OK on the Page Setup tab.
When you execute print, the document will be printed on one side of a sheet of paper. When the
printing of one side is complete, set the paper correctly by following the message and click OK. The
document will be printed on the opposite side.
Important
Duplex Printing is unavailable when:
A media type other than Plain Paper or Hagaki is selected from the Media Type list.
Poster is selected from the Page Layout list.
When Booklet is selected from the Page Layout list, Duplex Printing and Staple Side appear grayed
out and are unavailable.
After printing the front page, there is an ink drying wait time before starting to print the back page
(Operation stops temporarily). Do not touch the paper during the time. You can change the ink
drying wait time at Custom Settings on the Maintenance tab.
When you perform the automatic duplex printing for Hagaki, print an address first and then print your
message.
Note
If the Media Type dialog box appears when performing borderless printing during duplex printing,
select Plain Paper.
When performing the automatic duplex printing, do not use any plain paper smaller than A5. Also,
do not select any type of paper other than Plain Paper or Hagaki at Media Type.
If the back side of the paper becomes smudged during duplex printing, perform Bottom Plate
Cleaning in the Maintenance tab.
Page top
Page 309 of 997 pages Duplex Printing