Canon mx860 - Manual (Page 802)

Advanced Guide > Changing the Machine Settings > Changing the Machine Settings on the LCD > Advanced settings
Advanced settings
Read/write attribute
Selects whether to allow data to be written onto memory cards from a computer.
Important
Remove the memory card before changing this setting. For details, see Setting Up the Card
Slot as the Memory Card Drive of the Computer .
If you set this setting to Writable from USB PC or Writable from LAN PC, card direct printing
cannot be done. After you finish operation of the memory card dedicated drive, be sure to set it
back to Not writable from PC. When you turn off the machine, Writable from USB PC or Writable
from LAN PC will be canceled and the setting is returned to Not writable from PC when you turn
on the machine next time.
Volume control
Selects the volume.
Keypad volume
Selects the beep volume when pressing the buttons on the Operation Panel.
Alarm volume
Selects the alarm volume.
Country select
Selects the country where you are using the machine.
Note
This setting may not be available depending on the country or region of purchase.
Quiet mode
Enables this function on the machine if you want to reduce the operating noise, such as when
printing at night.
Enabling this function reduces the noises generated in the following cases:
Copying
Printing from a memory card
Printing from a PictBridge compliant device
Printing from a wireless communication device
Receiving the fax
Sending the fax
Printing a template form
Important
Operating speed may be reduced compared to when this setting is set to OFF.
This function may not be so effective depending on the machine's setting.
Furthermore, certain noise, such as when the machine is preparing for printing, is not reduced.
Note
The noises generated while scanning or printing from the computer can also be reduced. To
reduce these noises, you need to configure the settings on the computer.
For the noises while scanning, refer to
Scanner Tab .
For the noises while printing from the computer, refer to Reducing the Machine Noise .
Key repeat
Enables/Disables continuous input by pressing and holding down the , , , or button
when setting the number of copies, the zoom ratio, etc.
Two-sided output setting
Page 802 of 997 pages Advanced settings