Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 49)

2
-
Installation
45
5
-
Special
Install
5 - Special Installations
There may be situations that require special installations of Workboat Navigator.
Two such situations include:
Moving Workboat Navigator to a different computer while retaining the original
eToken
Installing Workboat Navigator on multiple computers. This is typically called a
Fleet Installation.
Moving to a Different Computer
Workboat Navigator is designed to quickly move an existing Workboat Navigator
installation from one computer to another using the same eToken. This allows you
to easily replace damaged hardware and upgrade systems as needed. Follow the
steps below to properly prepare the new system and move the eToken to the new
computer.
Run C- Map User Setup
Preparation Steps
Install Workboat Navigator, charts, and NavData on a new computer. This may
be done ahead of time in the office. You do not need to be on the boat. See
steps 1 through 3 in “Chapter 2 - Installation” of this guide.
Copy the license file to a USB device, writable compact disc, or another portable
data device.
Replace the old computer on the boat with the new computer that has Workboat
Navigator and the NavData installed.
Open Start | Programs | Jeppesen Marine | Support Tools | C-Map User
Setup. A message appears asking you to insert an eToken.
Insert the boat’s eToken into a USB port and wait for the red light on the eToken
to stop flashing. Setup may not work properly if you start it before the red light
stops flashing.
Click Yes. A message appears asking if you want to re-initialize Workboat
Navigator.
Click Yes. A message appears warning that you will lose all C-Map licenses.
Click Yes. A message appears noting that user setup was successful.
Click OK to finish.
•
•
1.
2.
3.
4.
5.
6.
7.
8.
9.
5