Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 9)

2
-
Installation
5
2 - Installation
Before You Install
Product Security Key (eToken)
Each licensed copy of Jeppesen Workboat Navigator comes with a USB port
device called a Product Security Key or an eToken. The eToken provides system
verification that you are using a licensed copy of the software and NavData.
Jeppesen Workboat Navigator will not open without an eToken.
WARNING
: Before you install the software, make sure that the Product Security
Key (eToken) is not plugged into a USB port. During software installation,
you will be prompted by the Setup Wizard to plug your Product Security Key
into an available USB port. If you try to install the software when there is an
eToken in the USB port you will get a corrupted installation.
eToken System ID
Each copy of Workboat Navigator is also assigned a unique identifier called the
eToken System ID, specific to that copy of Workboat Navigator. This System ID is
printed on the tag attached to the eToken. The System ID and the eToken are used
to manage your subscription and chart permits.
Disk Space
WARNING
: Make sure there is enough disk space on the computer used for
the Workboat Navigator installation. If there is not enough disk space for an
install, a warning message will appear but the install will appear to continue.
The resulting installation may be corrupt or fail, which could cause system
problems. For a clean installation, please ensure that you have enough disk
space (see System Requirements on Page iii) before installing.
2