Dell 2135cn Color Laser Printer - Manual (Page 56)

To configure TCP/IP settings.
Values:
Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and then on again.
Values:
IP Filter
Purpose:
To block data received from certain IP addresses through the wired network. You can set up to five IP addresses. The change becomes effective after the
printer is turned off and then on again.
Values:
Initialize NVM
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting the printer, all wired network settings are
reset to their default values.
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
Get IP
Address
DHCP/Autonet*
Sets the IP address automatically. A random value in the range of 169.254.1.0 to 169.254.254.255 that is not currently in use
on the network is set as the IP address. The subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually on the operator panel.
IP Address
When an IP address is being set manually, the IP is allocated to the printer using the format nnn.nnn.nnn.nnn. Each octet
that makes up nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
Subnet Mask
When an IP address is being set manually, the subnet mask is specified using the format nnn.nnn.nnn.nnn. Each octet that
makes up nnn.nnn.nnn.nnn is a value in the range of 0 to 255. 255.255.255.255 cannot be specified as the subnet mask.
Gateway Address
When an IP address is being set manually, the gateway address is specified using the format nnn.nnn.nnn.nnn. Each octet
that makes up nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
LPD
Enable* Enables the Line Printer Daemon (LPD) port.
Disable Disables the LPD port.
Port9100
Enable* Enables the Port9100 port.
Disable Disables the Port9100 port.
SNMP UDP
Enable* Enables the Simple Network Management Protocol (SNMP) UDP port.
Disable Disables the SNMP UDP port.
E-Mail Alert
Enable* Enables the E-Mail Alert feature.
Disable Disables the E-Mail Alert feature.
EWS
Enable* Enables an access to Dell Printer Configuration Web Tool embedded in the printer.
Disable Disables an access to Dell Printer Configuration Web Tool embedded in the printer.
No. n/Address (n is 1-5.) Sets the IP address for Filter n.
No. n/Mask (n is 1-5.) Sets the address mask for Filter n.
No. n/Mode (n is 1-5.)
Off* Disable the IP Filter feature for Filter n.
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.
NOTE: This item is only available for LPD or Port9100.