Dell 2135cn Color Laser Printer - Manual (Page 57)

Receive Mode
Purpose:
To select the default fax receiving mode.
Values:
Auto Rec Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call. The interval can be specified within the range of 0 to
255 seconds. The default is 0 second.
Auto Rec Fax/Tel
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external telephone receives an incoming call. The interval can be specified
within the range of 0 to 255 seconds. The default is 6 seconds.
Auto Rec Ans/Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external answering machine receives an incoming call. The interval can be
specified within the range of 0 to 255 seconds. The default is 21 seconds.
Line Monitor
Purpose:
To set the volume of the line monitor, which audibly monitors a transmission through the internal speaker until a connection is made.
Values:
Ring Tone Volume
Purpose:
To set the volume of the ring tone, which indicates that an incoming call is a telephone call through the internal speaker when Receive Mode is set to
Telephone/Fax
.
Values:
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Ans
Machine/Fax* The printer can share a telephone line with an answering machine. In this mode, the printer will monitor the fax signal and pick up the line
if there are fax tones. If the phone communication in your country is serial, this mode is not supported.
DRPD
Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a separate number for faxing with a distinctive ring pattern, configure the
fax setup to monitor for that specific ring pattern.
Telephone
Automatic fax reception is turned off. You can receive a fax by picking up the handset of the external phone and then pressing the remote
receive code, or by setting OnHook to On (you can hear voice or fax tones from the remote machine) and then pressing .
Fax Automatically receives faxes.
Telephone/Fax
When the printer receives an incoming fax, the external telephone rings for the time specified in Auto Rec Fax/Tel, and then the printer
automatically receives a fax. If an incoming call is not a fax, the printer beeps from the internal speaker indicating that the call is a
telephone call.
Medium* Sets the volume of the line monitor to Medium.
High Sets the volume of the line monitor to High.
Off Turns off the volume of the line monitor.
Low Sets the volume of the line monitor to Low.
High* Sets the volume of the ring tone to High.
Off Turns off the volume of the ring tone.