Dell UPS 10000R - Manual (Page 19)

19 Installation |
Rackmount Setup
CAUTION: The cabinet is heavy (see page 79): Always remove both battery trays from the UPS before lifting
the cabinet and installing the UPS on the rails in the rack. Lifting the cabinet into the rack requires a minimum
of two people.
CAUTION: Installing or removing the batteries should be performed or supervised by personnel
knowledgeable about batteries and the required precautions. Keep unauthorized personnel away from
batteries.
CAUTION: The batteries are heavy (32 kg/71 lb). Use proper lifting techniques when removing the batteries.
CAUTION: If installing an optional EBM, the EBM must be located below the UPS with no U space between
the UPS and EBM. This provides better weight distribution in the rack, easier access to the UPS control panel,
and easier routing for the battery cable connections. This also prevents strain between the EBM cord and the
UPS connection and possible connection failure.
WARNING: For Rack-Mounted Systems: When installing multiple systems in a rack, complete all of the
procedures for the current system before attempting to install the next system.
NOTE: Mounting rails are required for each individual cabinet.
NOTE: The cabinet is shipped without the front cover attached.
NOTE: The following instructions are the same for square-hole racks and unthreaded, round-hole racks. The
rails fit both rack styles.
To install the UPS in a rack:
1 Ensure that the following are placed on a flat, stable surface near the rack where you will install the
UPS:
S cabinet
S two accessory boxes
S two battery trays (UPS only)
S two battery retaining brackets (UPS only)
2 Remove the rails from the rail kit accessory box.
3 Select the proper holes in the rail for positioning the cabinet in the desired location in the rack.
Locate the rails at the bottom of the 5U space allocated for the UPS.