Dell UPS 10000R - Manual (Page 25)

25 Installation |
1
2
Figure 17. Installing the Front Cover
Installing the UPS
To install the UPS:
1 If you plan to use Dell MUMC and Dell ULNM software, establish communication in one of the
following ways:
S using the Dell UPS Network Management Card (if installed)
S using the supplied cable to connect your computer to the USB port
For more information about communication options, see page 62.
2 If your rack has conductors for grounding or bonding of ungrounded metal parts, connect the
ground cable (not supplied) to the ground bonding screw. See “UPS Rear Panels” on page 34 for
the location of the ground bonding screw for each model.
3 If an emergency power-off (disconnect) switch is required by local codes, see the following section,
“Installing Remote Emergency Power-off” to install the emergency disconnect switch before
powering on the UPS. See “UPS Rear Panels” on page 34 for the location of the REPO connector
for each model.
4 Plug the equipment to be protected into the UPS output receptacles, but do not turn on the
protected equipment.
5 Make any necessary provisions for cord retention and strain relief.