Dell PowerEdge R815 User Manual
Page 136
136
Installing System Components
4 Remove the cooling fan assembly. See "Removing the Cooling Fan
5 If applicable, remove the cables on the power distribution board.
6 Separate the system board and the I/O board to disengage the
interconnect between the power distribution board and the I/O board:
a
Slightly lift the tab on the high-speed connector to free the release
b
Push the release levers at an angle of 90 degrees away from the
connector to separate the system board and the power distribution
board from the I/O board. See Figure 3-30.
7 Press the release tab in the direction of the arrow and slide the board
upwards. See Figure 3-28.
8 Pull the power distribution board up until the securing slots on the board
are free from the tabs on the chassis. See Figure 3-28.
book.book Page 136 Wednesday, December 18, 2013 2:48 PM