Dell 3130cn Color Laser Printer - Manual (Page 131)

To specify PostScript communication protocol for each interface. You can configure the Adobe Protocol settings for the
wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto* Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary Used when no special processing is required for data.
Parallel
The Parallel menu can be adjusted to configure the parallel interface.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Port Status
Purpose:
To enable or disable the parallel interface. The change becomes effective after the printer is turned off and then on again.
Values:
Enable* The parallel interface is enabled.
Disable The parallel interface is disabled.
ECP
Purpose:
To specify the ECP communication mode of the parallel interface. The change becomes effective after the printer is turned
off and then on again.
Values:
Enable* The ECP communication mode is enabled.
Disable The ECP communication mode is disabled.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for parallel interface. You can configure the Adobe Protocol settings for the
wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP*
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary Used when no special processing is required for data.