Dell 3130cn Color Laser Printer - Manual (Page 221)

There are three separator rollers in the printer which need to be replaced periodically. One is in the tray and the others
are inside the printer. All the separator rollers are replaced in the same way as described in this section.
CAUTION: To prevent electric shock, always turn off the printer and disconnect the power cable from
the grounded outlet before performing maintenance.
CAUTION: Before performing any of the following procedures, read and follow the safety instructions in
your Product Information Guide.
Dell separator rollers are available only through Dell. To order by phone, see "Contacting Dell" .
It is recommended to use a Dell separator roller for your printer. Dell does not provide warranty coverage for problems
caused by using accessories, parts, or components not supplied by Dell.
Removing the Used Separator Roller in the Tray 1
NOTE: Remove all paper or media from the tray before pulling the tray out of the printer.
1. Pull the tray 1 out of the printer carefully. Hold the tray with both hands, lift the front slightly, and pull it out of the
printer.
NOTE: Ensure that you remove all the paper from the tray 1 before removing the separator roller.
NOTE: Carefully replace the tray 1 so it does not fall down.
2. Push the handles back on each side of the separator roller cover as shown in the following illustration and open the
cover.
3. Turn the separator roller until the roller hook is visible.