Installing optional modules, Installing the 550 sheet feeder – Dell 3130cn Color Laser Printer User Manual
Page 45
Installing Optional Modules
Installing the 550 Sheet Feeder
Installing the Network Protocol Adapter
Installing and Configuring the Wireless Printer Adapter
You can make the printer more functional by installing the options. This chapter describes how to install the printer's options such as the duplexer and 550 sheet feeder.
Installing the 550 Sheet Feeder
CAUTION:
If you are adding a 550 sheet feeder after setting up the printer, be sure to turn off the printer, unplug the power cable, and disconnect all cables from the back of the printer before completing these tasks.
1. Turn off the printer and unplug the power cable. Then, disconnect all cables from the back of the printer.
2. Remove all packaging from the 550 sheet feeder.
3. Place the 550 sheet feeder in the location that the printer is located.
4. Lift the printer and align the four guide pins of the 550 sheet feeder with the holes at the bottom of the printer. Gently lower the printer onto the 550 sheet feeder.
CAUTION:
To lift the printer safely, lift it with two people facing the front and back. Never try to lift the printer while facing its right and left sides.
CAUTION:
Be careful not to pinch your fingers when lowering the printer onto the 550 sheet feeder.
5. Pull the tray 1 out of the printer until it stops. Hold the tray with both hands, lift the front slightly, and remove it from the printer.
6. Join the 550 sheet feeder and the printer by tightening the two screws provided with the feeder with a coin or similar object.