Dell 2155cn/cdn Color Laser Printer - Manual (Page 245)

Dell Printer Configuration Web Tool 243
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the
Reset IPsec menu on the operator panel.
802.1x
Purpose:
To specify the settings for IEEE 802.1x authentication for encrypted
communication to the printer.
Values:
IPsec Settings Protocol Select the check box to enable the protocol.
IKE Sets IKE authentication. IKE is fixed to Pre-
Shared Key.
Pre-Shared Key Sets a shared key. Up to 255 alphanumeric
characters, periods, and hyphens can be used.
Re-enter Pre-
Shared Key Enters the shared key again to confirm it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800
minutes.
IPsec SA
Lifetime Sets the lifetime for IPsec SA from 5 to 2,880
minutes.
DH Group Sets the DH group.
PFS Select the check box to enable the PFS setting.
Remote peers
IPv4 address Sets the IP address to connect to.
Remote peers
IPv6 address Sets the IP address to connect to.
Non IPsec
communication
policy Allows communication with a device which
does not support IPsec.