Dell PowerEdge C1100 - Manual (Page 46)

46 Using the System Setup Program
Remote Access Configuration
NOTE: When Flow Control is set to Software, the Hyper Terminal on remote side is
discontinued by pressing <Ctrl><S>. But the <Ctrl><S> is also the Setup Key Stroke
for setting onboard NIC PXE Option ROM Configuration. Therefore, we suggest
users change <Ctrl><S> to <Ctrl><B> in PXE OPROM Configuration in order to avoid
that the Hyper Terminal on remote side is discontinued when pressing <Ctrl><S>.
Option Description
Remote Access (Enabled
default)
Selects remote access type.
Serial Port Number
(COM1 default)
Selects serial port for console redirection.
Current SOL Baud Rate Displays the current SOL Baud Rate.
Serial Port Mode
(115200 8,n,1 default)
Selects serial port settings. The default value may change
if SOL baud rate is fixed by customer request.
Flow Control
(None default)
Selects flow control for console redirection.
Redirection After BIOS
POST (Enabled default)
Selects the settings for the redirection.
• Disabled: turns off the redirection after POST.
• Enabled: redirection is always active.
Terminal Type
(ANSI default)
Selects the target terminal type.
book.book Page 46 Tuesday, February 26, 2013 11:33 AM